che serve per l'aggiornamento del firmware

Smaller than you think

The CNC cooling casing

1x USB-C cable

RadioMaster AG01 CNC Hall Gimbal albero cavo (set da 2) latenza che serve per l'aggiornamento delAG01 CNC Hall Gimbal (HOLLOW SHAFT version) Based on feedback from some players, Radiomaster has specially designed the AG01 Hall Gimbal HOLLOW SHAFT set. These gimbals have a hollow shaft to allow wiring for aftermarket 4mm gimbal stick ends with buttons, switches, etc. These are for special use cases only. Unless this is required, normal AG01 CNC Hall Gimbals should be selected. *Special version with hollow shaft for adding gimbal stick switches